تنظیمات نمایشگر SW900

P01: Backlight Brightness (1: darkest; 3: brightest)

P02: Mileage Unit (0: km; 1: mile)

P03: Voltage Class (24V / 36V / 48V / 60V / 72V )

P04: Auto-Off Time (0: never, other value means time interval for display auto-off) Unit: minute

P05: Pedal Assist Level 0/3 Gear Mode: Gear 1-2V, Gear 2-3V, Gear 3-4V 1/5 Gear Mode: Gear 1-2V, Gear 2-2.5V, Gear 3-4V, Gear 4-3.5V, Gear 5-4V

P06: Wheel Size (Unit: inch Precision: 0.1)

P07: Motor Magnets Number (for Speed Test; Range: 1-100)

P08: Speed limit Range: 0-50km/h, no speed limit if set to 50) 1. Communications status (controller-controlled) The driving speed will be kept constant as the limit ed value

Error Value: ±1km/h (applicable to both the PAS/throttle mode) Note: The above-mentioned values are measured by metric unit (kilometers). When the measuring unit is set to imperial unit (mile), the speed displayed on the panel will be automatically switched to corresponding imperial unit, however the speed limit value in the imperial unit interface won’t change accordingly.

P09: Direct Start / Kick-to-Start Setting 0: Direct Start 1: Kick-to-Start

P10: Drive Mode Setting 0: Pedal Assist – The specific gear of the assist drive decides the assist power value. In this status the throttle does not work. 1: Electric Drive – The vehicle is driven by the throttle. In this status the power gear does not work. 2: Pedal Assist + Electric Drive – Electric drive does not work in direct-start status.

P11: Pedal Assist Sensitivity (Range: 1-24)

P12: Pedal Assist Starting Intensity (Range: 0-5)

P13: Magnets Number in Pedal Assist Sensor (5 / 8 / 12pcs)

P14: Current limit Value (12A by default; Range: 1-20A)

P15: Unspecified

P16: ODO Clearance Press and hold the up key for 5 seconds and ODO distance will be cleared.

انواع نمایشگر و صفحه کیلومتر دوچرخه، موتور و خودروهای برقی با مانیتور LCD و LED دیجیتال و آنالوگ با قابلیت های نمایش سرعت نهایی، مسافت پیمایشی، تنظیمات کنترلر و نشانگرهای علائم حرکتی